Sump Pump Installation in Denver, CO
A sump pump is the difference between a damp spring and a flooded basement. Denver gets its water fast, in spring melt and in hard summer storms, and a finished basement with no pump is a bet on the weather.
- Primary pumps, battery backups, and full pit installs
- Discharge routed away from the foundation, not into the sewer
- 24/7 help when a pump fails during a storm
Get A Free Quote
We reply fast. Same day when possible.
What it is
Sump pump installation Sump pump installation is the process of setting a pump into a basement sump pit and connecting it to a discharge line so it automatically pumps groundwater away from the foundation before it can flood the basement.
Denver's spring snowmelt and heavy summer rains can push groundwater up around a foundation, and a working sump pump is often the only thing standing between that water and a flooded basement.
The pump is only as good as the pit and the discharge
Most sump failures are not the motor. They are a float jammed against the pit wall, a discharge line that freezes at the elbow, or a check valve that lets water fall right back in. A correct install fixes all three at the start.
- Properly sized pit with a sealed lid
- Cast iron or quality thermoplastic pump matched to inflow
- Check valve so water does not cycle back down
- Discharge that clears the foundation and does not freeze shut
You need a sump pump if
- Water shows up on the basement floor during heavy rain or melt
- There is an open pit with no pump in it
- The existing pump is over seven years old
- You are finishing the basement
- Efflorescence or a water line stain runs along the foundation wall
What a sump pump install includes
- Pit sizing and placement at the low point of the slab
- Pump selection matched to expected inflow, not just the cheapest unit
- Check valve and rigid discharge piping
- Sealed lid to control radon and humidity
- Discharge routed well away from the foundation with a freeze-resistant termination
- Optional battery backup or water-powered backup for outage protection
What to expect and how the work gets done
- 1
Assess the basement
Find the low point, check for an existing pit, and trace where water enters.
- 2
Set the pit
Cut and place the basin if one does not exist, with gravel base and sealed lid.
- 3
Plumb and power
Pump, check valve, rigid discharge, and a dedicated GFCI outlet.
- 4
Test
Fill the pit, watch the float cycle, and confirm the discharge runs clear.
Credentials, reviews, and company proof
- Colorado Master PlumberFixture and appliance work is permitted and code-compliant, not handyman work.
- Plumbing Contractor license 2110Licensed to pull permits and pass inspection on gas, water, and drain work.
- Serving Denver since 2006Two decades of Front Range water chemistry, altitude, and inspection practice.
Ready when you are
Tell us what is happening and your Denver neighborhood. We will route it fast.
What drives sump pump cost
Dropping a pump into an existing pit is straightforward. Cutting a new pit into a slab is the expensive version.
Need help right now? 24/7 emergency plumbing service. Planning a larger repair? See financing options.
- Whether a pit already exists or has to be cut into concrete
- Pump horsepower and housing material
- Length and routing of the discharge line
- Battery backup system and its battery
- Adding a sealed lid and radon-rated cover
- Electrical work if there is no outlet nearby
Frequently asked questions
Licenses, credentials, and company proof
- Colorado Master PlumberLicense MP-18927
- Colorado State Plumbing ContractorLicense 2110
- Family Owned & OperatedServing Denver since 2006, 20 years
- Better Business BureauAccredited Business, A+ rating
- Angie's List Super Service Award2012 through 2017
- Serving Denver since 2006Residential and commercial properties across the metro
More plumbing help from Afford-A-Rooter
- Garbage Disposal ReplacementGarbage disposal leaking or humming? We replace disposals in Denver, check the drain arm, and size the horsepower right. Call (720) 296-7972.View page
- Toilet InstallationNew toilet installation in Denver. Rough-in measured, flange repaired, new supply and seal, old toilet hauled away. Call (720) 296-7972.View page
- Faucet ReplacementDripping or corroded faucet in Denver? We replace kitchen and bath faucets, plus the shutoff valves that never close. Call (720) 296-7972.View page
- Shower Valve ReplacementShower scalding when a toilet flushes? We replace shower valves in Denver with pressure balance units, often without removing tile.View page
- Water Softener InstallationHard water scaling your Denver plumbing? We test hardness, size the softener, and plumb the loop and drain to code. Call (720) 296-7972.View page
- Pressure Reducing ValveHigh water pressure in Denver wrecks fixtures. We test static pressure and replace failed PRVs, expansion tank included. Call (720) 296-7972.View page
Protect the basement before the next storm
Free quote on pump, pit, and backup options.